DCT Syrus - ST - GPS Receiver Status

rev1 – Dec 2013 www.digitalcomtech.com 40
ST - Status
Qualifiers: Q, R.
This message provides information about the unit's GPS receiver. The message has the
following format when using no modifier (>QST<):
AABCDDEFGGH
o AA: GPS satellite signal acquisition and tracking status.
 00: Doing position fixes.
 01: Don't have GPS time yet.
 02: Not used.
 03: HDOP is greater than 1.5.
 08: No usable satellites.
 09: Only 1 usable satellite.
 0A: Only 2 usable satellites.
 0B: Only 3 usable satellites.
 BB: Stationary Mode.
 0C: Chosen satellite is unusable.
o B: Antenna short circuit state
 0: No problems reported.
 1: Antenna feed line short fault.
o C: Status Codes, Nibble 2:
 Currently not in use.
o DD: Machine ID. Internal GPS machine ID. Currently not in use.
o E: Status Codes, Nibble 3:
 Currently not in use.
o F: Status Codes, Nibble 4:
 Currently not in use.
o GG: Hex value. Currently not in use.
o H: Indicates if the GPS is on or off. Flag:
 0: GPS is off
 1: GPS is on