DCT Syrus - RF - Radio Frequency Configuration

To Next Page

To Previous Page

rev1 – Dec 2013 www.digitalcomtech.com 36

RF - Radio Frequency Module Configuration

Qualifiers: Q, S, R.

This message is used to configure Cellular Network parameters. Any RF parameter can be

left empty by issuing the command without the B string. The message has the following

format

A[BBB...]

A: RF parameter to be configured. The valid values for this field are:

A: GPRS APN (Access Point Name) (40 chars. max.).

I: SIM Card PIN.

L: GPRS Login (40 chars. max.).

P: GPRS Password (40 chars. max.)

[BBB...]: String with the parameter described by A. It cannot contain the "<" or the

";" characters.

Warning:

The SIM card may be blocked if the RFI parameter is configured with a wrong SIM card PIN.

Examples:

To set the PIN number 1234, send to the unit:

>SRFI1234<

If the SIM card does not required a PIN, set an "empty" PIN:

>SRFI<

To set the APN to internet.carrier-name.com send to the unit:

>SRFAinternet.carrier-name.com<

To leave the APN parameter empty:

>SRFA<