Need help?Do you have a question about the DCT Syrus and is the answer not in the manual?
Discusses compatibility between Syrus firmware and hardware versions.
Details electrical specifications including voltage, current, and protection.
Describes available input ports and ignition sensing capabilities.
Details output capabilities, current, voltage, and protection.
Specifies operating and storage temperature, and humidity.
Lists GPS receiver model, frequency, and sensitivity details.
Details the time taken for GPS to acquire a fix.
Details GPRS data speeds and coding schemes.
Explains the SYS LED status indicators and their meanings.
Explains the GPS LED status indicators and error conditions.
Explains the NET LED status indicators for GSM registration.
Specifies temperature limits for battery operation and charging.
Step-by-step guides for safe SIM card removal and PIN setup.
Warning about insulating exposed wire ends to prevent damage.
Lists required environmental conditions for installation.
Guidance on placing the unit for optimal internal antenna performance.
Instructions for connecting the unit to power sources.
Directs users to the support site and software for initial setup guidance.
Instructions on how to set the unit's unique identification.
Steps to configure APN and PIN for GPRS network access.
Example of configuring a periodic report event.
Example of creating an event triggered by an input signal.
Example of setting up a panic button event.
Configuring multiple actions within a single event.
Guidance on verifying AVL application and server communication.
Explains how triggers are defined using logical combinations of signals.
Details the types of actions triggered events can perform.
Explains how triggers and actions are combined into events.
How to set and manage the unit's identification.
Using IMEI as the unit's identifier.
Instructions for configuring the SIM card PIN.
Defines and categorizes Destination Points for message routing.
Details the format and usage of the DA command.
Example of setting up a continuous timer counter.
Example of setting up a periodic timer counter.
Example of configuring a TCP destination point.
Example of configuring a UDP destination point.
Example of configuring a telephone destination point.
How to use the IMEI as the unit's identifier.
How to consult the unit's IMEI.
Configurations for slow traffic, power, ignition, and input/output status changes.
Configurations for low battery, GPS antenna faults, and restorations.
To Next Page
General