DCT Syrus - Destination Point Status Details

rev1 – Dec 2013 www.digitalcomtech.com 48
o GSM RSSI
 0 = -113 dBm or less
 1= -111 dBm
 2 to 30 = -109 to -53 dBm
 31 = -51 dBm or greater
 99 = not known or not detectable
o GPRS attached state
 0= Not attached*
 1= Attached
o GPRS register state
 0= Not registered*
 1= Registered
 2= Not registered, searching.
 3= Rejected
 4= Error
 5= Registered, Roaming.
o Local IP address
o GPRS bearer state
 0 = Bearer is down
 1 = Bearer is up
o Jamming state:
 -2 = Normal state
 0-60 = Jamming detection in progress
 -3, -1 = Jamming Detected
* This state can be reported when no TCP Destination Point is set. Consult the XADP message for more
information.
Third Group:
This group holds the information about each Destination Point set. Each destination
point is separated by a "\" character. If no destination point is set this group will be
empty. The Destination Points are listed in the chronological order they were
created. They are not listed by the index used by the XADP message.
The address of the IP destination point.
o Socket connection state
 0= Not connected
 1= Connecting
 2= Closing
 3= Connected
 4= Connected, limited.
 5= Closing, hold.
o Local port
o Remote IP address
o Remote port
o Socket up time
o Socket down time
o Socket down log timer