Connecting to a WPS network
Connecting to a WPS network.
0
If your wireless router support WPS (Wi-Fi Protected Setup™) this unit can optionally connect to your network using the push button
method by following these steps:
(Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.)
1.
Press the WPS button on your router.
2.
Within 2 minutes, press and hold the CONNECT button on the rear panel of the sound bar for 3 seconds.
3.
The status LED on the front of the sound bar will flash green for several seconds as it connects to your WPS router.
4.
When the connection is complete, the status LED on the front of the sound bar will turn solid green.
This unit takes long time to turn on
This unit takes long time to turn on.
0
In case this unit as in the deep standby mode, it may takes around 40 second to turn on.
Contents
Connections Playback Settings Tips Appendix
64
To Next Page
Loading...
Need help?
General
