Definox Sorio - Changing LED colours

MAINTENANCE NOTICE
NM-275 index 09 Page 26/50 September 2021
8.4 Changing LED colours
Factory default RGB LED
RGB LED Colour
Default position
Cyan
Open position () closed
Green
Close position (Open position)
Flashing green
Upper valve pulse
Flashing Cyan
Lower valve pulse
Flashing violet
Valve not calibrated
Yellow
Warning
Flashing yellow
Calibration in progress
Flashing Blue
Localisation
Error
Error
Off
Without position
White
Forced external signal colour
8.4.1 Changing RGB LED colour valve open / valve closed:
1) Press the button for at least 5 seconds to enter the colour change mode.
The colour RGB LED valve idle flashes. (Default Cyan)
2) Press the button several times until the desired valve colour is found
Choose the
colour for idle
Button
Effect
Led column
RGB Led
Change to off
S
off
Change to white
A
White flashing
Change to green
M
Green flashing
Change to blue
T
Blue flashing
Change to yellow
S A
Yellow flashing
Change to Cyan
SM
Cyan flashing
Change to Violet
ST
Flashing violet
5 sec.
x clicks