4.24 Flip flops
Description Notes
Flip flop output [1-16] The event is active when the flip flop is set or toggled.
4.25 Power limit outputs
These events are only available in genset controllers.
Description Notes
Power Limit Output [1-4] Indicates which Power Limit Output is active.
4.26 Easy connect
These events are only available in genset controllers.
Description
Notes
Plant active The event is active when the controller is in a power management system.
Stand-alone The event is active when the controller is not in a power management system.
4.27 Grid support
These events are only available in genset controllers.
Description
Notes
Power Ramp [1-4] active The actual power ramp [1-4] is active.
Default Var Reg variant active Default Var Regulation variant is active.
Var Reg variant [A-D] active The actual Var Regulation variant [A-D] is active.
Q(u) variant A ext. control set to OFF Q(u) variant A external control set to OFF is active.
Q(u) variant A ext. control set to
MODBUS
Q(u) variant A external control set to MODBUS is active.
Q(u) variant A ext. control set to
ANALOGUE
Q(u) variant A external control set to ANALOGUE is active.
Q(u) variant C ext. control set to OFF Q(u) variant C external control set to OFF is active.
Q(u) variant C ext. control set to
MODBUS
Q(u) variant C external control set to MODBUS is active.
Q(u) variant C ext. control set to
ANALOGUE
Q(u) variant C external control set to ANALOGUE is active.
Application note 4189341276B EN Page 32 of 50
To Next Page
Loading...
Need help?
General
