Description Notes
Block mode Block running mode.
Lamp test Activate lamp test (LEDs on display).
Ack. all alarms Acknowledge all alarms.
Set to local start Select local start in a power management application.
Set to remote start Select remote start in a power management application.
Set clock to 4 am Set the controller clock to 04h00.
Set BA parameter [1-4] Choose the parameter set for nominal settings for busbar A.
Activate capacity overrule See Option G7 Extended power management.
Deactivate capacity overrule See Option G7 Extended power management.
TB close inhibit Prevents the tie breaker from closing.
Select application [1-4]
Power management: Select the power management application from the
controller.
Update mode local
The running mode for the local controller in the power management system is
updated to the selected mode.
Update mode on all
The running mode for all controllers in the power management system is updated
to the selected mode.
Store common settings See Handling settings for sections in Option G5 Power management.
Open TB Open the tie breaker.
Close TB Close the tie breaker.
Auto start/stop ON = Start, OFF = Stop.
First priority Forces this controller to have the first priority in a power management system.
Activate Asymmetric LS Activate asymmetric load share.
Deactivate Asymmetric LS Deactivate asymmetric load share.
Select three phase system Sets the controller to work in a three-phase system.
Select split L1L3 phase system Sets the controller to work in a two-phase system (L1-L3).
Select split L1L2 phase system Sets the controller to work in a two-phase system (L1-L3).
Select single phase system Sets the controller to work in a single-phase system (L1).
Inductive reference Inductive cos phi reference.
Capacitive reference Capacitive cos phi reference.
Act. power offset [1-3] Activate the power reference offset.
Deact. power offset [1-3] Deactivate the power reference offset.
Act. cos phi offset [1-3] Activate cos phi reference offset.
Deact. cos phi offset [1-3] Deactivate cos phi reference offset.
Reset horn Reset the horn relay.
Reset I max. demand Reset the peak current detected in the controller.
Reset I thermal demand Reset the thermal current detected in the controller.
Pulse counter [1-2] Increase the selected pulse counter.
Reset pulse counter [1-2] Reset the selected pulse counter.
Set BB parameter [1-2] Select the parameter set for busbar nominal settings.
Ack. mains protection alarms
Acknowledges all mains alarms including: 1270-1430, 1660, 1700, 1960, 1970,
7480-7490.
Application note 4189341276B EN Page 40 of 50
To Next Page
Loading...
Need help?
General
