4.8 Sequences
4.8.1 Sequences
The following contains information about the sequences of the engine, the generator breaker, and the mains
breaker. These sequences are automatically initiated if the auto mode is selected.
In the manual mode, the selected sequence is the only sequence initiated (e.g. press the START push-but-
ton: the engine will start, but not close the breaker).
The following sequences will be illustrated below:
● START sequence
● STOP sequence
● Breaker sequences
The stop coil function can only be used in relays 24,26, 45 and 47.We recomment that a resistor
is mounted across the relay coil to prevent undesirable closing of the relay.
CGC 400 DRH 4189340786 UK Functional descriptions
DEIF A/S Page 32 of 96
To Next Page
Loading...
