DESIGNER’S HANDBOOK 4189350049C EN Page 119 of 206
10.2.1.1 Colour shift source in mode 1
In mode 1, the source used to make the colour selection can be:
Select this setting if a fixed design is needed (Day, Dusk or Night).
Parameter is received from digital input, when the digital input
dimmer mode supporting colour shift is selected.
Parameter is received via CAN using XDi-net format or received in a
DAM-MPDO.
Parameter is received via CAN in a TPDO or RPDO, and has to be
predefined in the selected PP.
Front buttons
Front b.& Digital opt.
Reserved for future XDi-N version (Not available in this version)
10.2.1.1.1 Colour shift using XDi-net or DAM-MPDO
This selection has no setup menu. The colour pallet selection is received in sub-index 0x03 of the dimmer group
object index range in the table above. The selection is located in an unsigned 8 bit field using only 2 bits (LSBs).
The 2 bit selection values are:
00 = Day
01 = Night
10 = Dusk
11 = Reserved
See the “XDi-net/CANopen reference manual” for details.
10.2.1.1.2 Colour shift using PDO converter
If the colour shift is defined in the Product Profile (PP) to be received using a TPDO or RPDO, then a PDO
converter is used as the input source for colour shift. The PDO converter can select any 2 bits in the 8 byte data
package and use them as colour shift input. This means that it is possible to map colour shift parameters for all 9
dimmer groups in one TPDO using only 3 data bytes with data for up to 4 groups in each byte.
To Next Page
Loading...
Need help?
General
