Preliminary
941322_VMS Instruction Book 2006.pdf2009-09-07
No. Name Range Default Description/optionsNo. Name Range Default Description/options
0 = no acidic cleaning0 = no acidic cleaning
1 = one alkaline, one acidic cleaning1 = one alkaline, one acidic cleaning
2 = two alkaline, one acidic cleaning2 = two alkaline, one acidic cleaning
3 = etc.3 = etc.
Maintenance an calibration
The following points are important to sustain
correct dosing of etergents. Note that
these two tasks should be performed by an
authorised DeLaval service engineer.
• The tubes in the peristaltic pumps should
be replaced at least two times a year.
• The dosing volume (P6-P8) of the
detergent pumps should be checked
every third month. The dosing capacity
(P32-P34) may need to be adjusted.
Starting cleaning or rinsing
from the touch screen
Note: Any ongoing backflush process must
first be finished before cleaning or rinsing
can be started.
1. Ensure that the milking station is in
manual mode.
2. Remove any cow that might be in the
milking station.
After treatment window
Note: Both gates should be closed to
prevent a cow from entering before the
system cleaning has been started. Closing
and opening gates is done in the Stall
control window.
3. Press the tab After Treatment on the
touch screen to display the After treatment
window.
4. In the After treatment window, press the
Cleaning and Rinsing button. This will open
the Cleaning and rinsing window.
6. Visually inspect the teats.
Note! Do not milk infected teats.
7. Press the large button to release the clus-
ter.
Note! With comfort start there is no need to
push the button, vacuum is applied to the
cluster when it is lifted. However, this is not
the case if the "Do not milk" or "Dump
milk" flags are active.
Note! If the animal is incorrectly blocked for
milking, see
Ä
Chapter 4.2 "Overriding a
blocking" on page 42.
8. Attach the cluster to the udder of the cow.
Note! Avoid that air enters the cluster
before the actual attachment.
Note! If needed, disable automatic retrac-
tion of the cluster by pressing the large but-
ton again to activate manual mode. For
more information,
Ä
Chapter 4.1 "Milking
in manual mode" on page 41
ð
The large button indicator light flashes
slowly in white until the milk flow is
above the low flow limit.
When the milk flow is above the low
flow limit, the large button indicator light
turns into a solid white.
When the flow is below the take-off
limit, the large button indicator light
flashes slowly in white until the cluster
is retracted.
The large button indicator light turns to
solid green at normal take-off.
DeLaval milking automation MA200 (Test installation)
Operation
© DeLaval 2019.
2019-05-31, Version 1 37 (62)
To Next Page
Loading...