V0608, 3.1
3. Programming of tools
3.1. Introduction
This chapter describes the programming of the tools.
3.2. Programming of Punches
3.2.1. Punch library
The programming of punches is started by pressing the tools key.
3.a
A maximum of 30 punches can be programmed. Tools that are not programmed show an
asterisk (*) beside the tool number.
Press this key for tool programming.
The first time this key is pressed, the screen for punch programming
appears. To switch to programming of bottom dies, press this key
again.
Use the arrow keys left/right to browse to the desired
tool in the library.
To Next Page
Loading...
