Delem DA-52 - Program Constants; Program Constants Introduction

V0608, 4.1
4. Program Constants
4.1. Introduction
4.2. General
4.a
Inch/mm-select . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..IS
1 = dimensions in inches
0 = dimensions in millimeters
Press this key to enter the program constants. The program
constants are divided across several pages. They are discussed in
the following sections.
Use the arrow keys left/right to browse through the
various pages with parameters. Use the arrow keys up/
down to select individual parameters.
At some parameters, a value can be selected with the
‘constants’ key. This is indicated by the symbol .