V0608, 1.3
1.3. Programming modes
The control has the following programming functions:
You select one of the programming modes in the manual- or automatic operation mode while
the controller is in the 'stop'-status.
Program
constants
In this mode you program the general
parameters for bend programming.
Tools In this mode you program and edit the tools.
There are 30 different punches and 30
different dies to program in the program
memory.
Change view Key to switch between various pages of a
bend.
It also serves to return to an active program.
Program
library
Open the library with bend programs on the
control.
To Next Page
Loading...
