Delem DA-52 - Page 29

V0608, 4.5
properties as the active bend. The following properties of a bend are compared:
- Material properties
- Thickness
- Die opening
- Die radius
- Punch radius
- Angle
The first five properties of a bend must be exactly the same as the active bend to start a
comparison. If the angle is the same as the angle of the active bend, the correction is
offered. If the angle of the active bend has a maximum difference of 10° with two
adjacent bends, a correction is interpolated from these two bends. If the resulting
correction has a difference of more than 5° with one of the two other bends, there will be
no correction offered.
Y opening default . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..13
Default Y-axis opening value.
The value programmed here is used as initial value for the parameter ‘Y-axis opening’ in
the Data Preparation menu of the programming mode.
Default X-axis code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..XC
Default value for the parameter ‘code’ in a bend program. This parameter determines
the moment of step change in a bend program. Initially the code parameter is set to the
value programmed here during postprocessing and during programming.
The default value of this parameter = 2.
See chapter ‘data preparation/data edit’ for more information about the code parameter.
Default X time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..XT
During the postprocessing, the waiting time of the X-axis at step change is put to zero.
With this parameter you can preset a longer waiting time when needed for product
handling.
Deafult hold time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..HT
Default value for the dwell time, the time the pressbeam stays at the bending position.