Delem
V0504, 19
Actual pos .............................................................. 03
You can program here the position at which the axis is
currently located. When you think that Xp is not showing
the correct position value, program here the correct
position value. Make sure this position is correct.
This parameter is only available if no reference search
system is used.
If operating without a reference encoder the actual back gauge
position read out will be memorized after power down.
Contrast.................................................................. 04
To set the contrast level for the display.
Backlight................................................................. 05
To set the level of illumination from the display.
To Next Page
Loading...
