Delem DAC-310 - Table of Contents

Delem
Manual version V0504, 3
Table of contents
PAGE
PREFACE ........................................................................... 1
LIMITED WARRANTY ................................................... 1
1. INTRODUCTION ...................................................... 1
2. HARDWARE.............................................................. 3
2.1. Front panel .......................................................................3
2.2. Display..............................................................................4
2.3. Front panel .......................................................................4
3. OPERATING MODES .............................................. 7
3.1. General.............................................................................7
3.2. Manual mode....................................................................8
3.3. Automatic mode................................................................9
3.4. Semi-automatic mode.....................................................10
4. PARAMETER PROGRAMMING......................... 11
4.1. Introduction.....................................................................11
4.2. Identification of a step.....................................................11
4.3. Programmable Parameters ............................................12
4.3.1. General..............................................................12
4.3.2. Actual position readout Xp ................................12
4.3.3. Back gauge position Xm....................................12
4.3.4. COR(rection) .....................................................13
4.3.5. Retract distance DX ..........................................13
4.3.6. Function Outputs F............................................14
4.3.7. Repetition CY ....................................................14
4.3.8. Stock Counter #.................................................15
4.3.9. Number of steps ST...........................................15
4.3.10. Stroke S.............................................................16
4.3.11. Gap G ................................................................16
4.3.12. Programming constants M ................................16
4.3.13. Programming key ..............................................16