Install the System in the Rack
T
opics:
• Remove filler panels
• Recommended rack locations for the system
• Identifying the rail kit components
• Remove the original CMA brackets
• Attach the new CMA brackets
• Install the rails
• Secure the rail assemblies to the cabinet
• Install the system in the cabinet
• Install the front bezel
• Install the CMA arms
Remove filler panels
The front space into which you will install the shelf is usually covered by a filler panel. If one or more filler panels cover the space
where you want to install the shelf, use this procedure to remove each panel.
Steps
1. On the filler panel, slide the left and right securing tabs to the open position (towards the center of the panel).
2. R
emove the filler panel from the cabinet.
Recommended rack locations for the system
Ensure that you install the system controllers and disk shelves in the appropriate rack locations.
NOTE:
The following recommended rack locations support the cabling described in this document. Installing in other
locations might require different cable lengths.
The following table lists the recommended locations for installing the system in the rack.
2
Install the System in the Rack 15
To Next Page
Loading...
