CLI equivalent
S
teps
1. To set up the administrator email, enter:
# config set admin-email dd_admin1@emc.com
T
he Admin Email is: dd_admin1@emc.com
2. To register the system to the gateway (Secure Remote Support), enter:
# support connectemc device register i
paddr esrs-gateway [host-list] [ha-peer ipaddr]
CAUTION:
When configuring Secure Remove Services delivery on an HA pair:
● The ha-peer parameter is required when configuring Secure Remote Services on HA pairs to register
both nodes.
● The customer must provide Service Link credentials to run the support connectemc device register
command on an HA pair, because attempting to register the HA pair as a user will fail and cause the RSA
key token to become out of synch.
3. T
o enable the sending of autosupports, enter:
# support notification enable all
E
nabled sending autosupport and alerts to EMC.
4. To set the notification method to ConnectEMC, enter:
# support notification method set connectemc
S
upport notification method set to "connectemc".
5. To show the notification setup, enter:
# support notification show all
N
otification Status Destination
------------ ------- -----------------------
alerts enabled ftp://111.111.11.111:11
autosupport enabled ftp://111.111.11.111:11
------------ ------- -----------------------
6. To show the notification setup, enter:
# support connectemc config show
C
onnectEMC configuration:
ESRS gateway IP/hostname: esrs-gateway.datadomain.com
Registered device IP(s) 10.25.246.70
7. To test the configuration after enablement, enter:
# support connectemc test
S
ending a test event...
Configure HA
Prerequisites
● The HA interconnect between both nodes is connected.
NOTE: C
onnecting the HA interconnect on page 59 describes how to cable the HA interconnect.
● T
he data connections on both nodes are connected.
About this task
Configure the two nodes as an HA pair.
NOTE:
Configuring an HA pair sets the system password on the standby node to match the system password on the active
node, however, that synchronization is not set until the HA configuration is complete. If the HA configuration fails, or if
82 Configure System for Use
To Next Page
Loading...
