Dell EMC VxRail E series - Processor specifications; PSU specifications; Expansion bus specifications

Processor specifications
The VxRail E Series appliance supports up to two Intel Xeon Processor Scalable Family processors.
PSU specifications
The VxRail E Series appliance supports two AC or DC power supply units (PSUs).
The table below are the specifications for 1100 W power supply:
Table 16 PSU specifications
PSU Class Heat
dissipation
(maximum)
Frequency Voltage
1100 W DC Gold 4416 BTU/hr 50/60 Hz –(48–60) V DC
1100 W Mixed
Mode HVDC
(for China
and Japan
only)
Platinum 4100 BTU/hr 50/60 Hz 100–240 V AC and 200–380
V DC
1100 W AC Platinum 4100 BTU/hr 50/60 Hz 100–240 V AC, autoranging
Note: If an appliance with 1100 W AC or HVDC PSU operates from 100 to 120V, the power
rating per PSU is derated to 1050 W.
Note: Heat dissipation is calculated using the PSU wattage rating.
Note: This appliance is also designed to connect to the IT power systems with a phase to
phase voltage not exceeding 240 V.
Battery specifications
The VxRail E Series appliance supports CR 2032 3.0-V lithium coin cell battery.
Expansion bus specifications
The VxRail E Series appliance supports PCI express (PCIe) generation 3 expansion cards, which
must be available on the system board by using expansion card risers.
This table provides information about the expansion card riser configuration for VxRail E Series
appliance.
Table 17
Expansion card riser specifications
Supported VxRail
configurations
Riser configuration
and supported risers
Slot
description
PCIe slots (Height
and length)
Processor
connection
VxRail E Series appliance
Riser configuration 2
(1A+2A)
Three x16
slots
Slot 1: x16 low profile,
half length
Processor 1
Slot 2: x16 low
profile, half length
Processor 1
Technical specifications
Dell EMC VxRail Appliances on PowerEdge Servers E Series Owner's Manual 23