Dell EMC VxRail E series - Memory specifications; Hard drive specifications; Ports and connectors specifications

Table 17 Expansion card riser specifications (continued)
Supported VxRail
configurations
Riser configuration
and supported risers
Slot
description
PCIe slots (Height
and length)
Processor
connection
Slot 3: x16 low
profile, half length
Processor 2
Riser configuration 4
(1A)
Two x16 slots
Slot 2: x16 low
profile, half length
Processor 1
Memory specifications
The table below shows the memory specifications for the VxRail
™
E Series appliance:
Table 18 Memory specifications
DIMM
type
DIMM rank
DIMM
capacity
Single processor Dual processors
Minimum
RAM
Maximum RAM Minimum RAM Maximum RAM
LRDIMM Quad rank 64 GB 384 GB 768 GB 768 GB 1536 GB
RDIMM Dual rank 16 GB 96 GB 192 GB 192 GB 384 GB
RDIMM Dual rank 32 GB 192 GB 384 GB 384 GB 768 GB
Storage controller specifications
The VxRail E Series appliance supports:
l
Internal storage controller cards: HBA330 and Boot Optimized Server Storage (BOSS-S1).
Hard drive specifications
The VxRail E Series appliance supports NVMe, SAS, SATA, Nearline SAS hard drives or SSDs.
The following table lists out the supported hard drive and SSD options for the VxRail E Series
appliance:
Table 19
Supported drive options
Ten drive appliances Up to ten 2.5 inch, hot swappable NVMe, SAS, SAS/
SATA SSD, or Nearline SAS hard drives.
Ports and connectors specifications
The VxRail E Series appliance supports USB ports, NIC ports, VGA ports, serial connector, and an
IDSDM card that supports two internal dual SD module.
USB ports
The following table provides more information about the USB specifications:
Technical specifications
24 Dell EMC VxRail Appliances on PowerEdge Servers E Series Owner's Manual