Table 3 Status LED indicators and descriptions (continued)
Icon Description Condition Corrective action
appliance
experiences a
thermal error (for
example, the
ambient
temperature is out
of range or there is
a fan failure).
l
A cooling fan has been removed or has
failed.
l
Appliance cover, air shroud, memory
module blank, or back filler bracket is
removed.
l
Ambient temperature is too high.
l
External airflow is obstructed.
If the problem persists, see the Getting help
section.
Electrical
indicator
The indicator turns
solid amber if the
appliance
experiences an
electrical error (for
example, voltage
out of range, or a
failed power supply
unit (PSU) or
voltage regulator).
Check the System Event Log or appliance
messages for the specific issue. If it is due to
a problem with the PSU, check the LED on
the PSU. Reseat the PSU. If the problem
persists, see the Getting help section.
Memory
indicator
The indicator turns
solid amber if a
memory error
occurs.
Check the System Event Log or appliance
messages for the location of the failed
memory. Reseat the memory module. If the
problem persists, see the Getting help
section.
PCIe
indicator
The indicator turns
solid amber if a
PCIe card
experiences an
error.
Restart the appliance. Update any required
drivers for the PCIe card. Reinstall the card.
If the problem persists, see the Getting help
section.
Note: For more information about the
supported PCIe cards, see the Expansion
card installation guidelines section.
Appliance health and appliance ID indicator codes
The appliance health and appliance ID indicator is located on the left control panel of your
appliance.
Figure 3
Appliance health and appliance ID indicators
This table describes the appliance health and appliance ID indicators. Item 1 indicates Solid blue
where the condition indicates that the appliance is turned on, appliance is healthy, and appliance ID
mode is not active. Press the appliance health and appliance ID button to switch to appliance ID
mode. Item 2 indicates Blinking blue where the condition indicates that the appliance ID mode is
active. Press the appliance health and appliance ID button to switch to appliance health mode.
Overview
8 Dell EMC VxRail Appliances on PowerEdge Servers E Series Owner's Manual
To Next Page
Loading...
