LED Description
• Flashing green—port activity
Table 4. QSFP28 port LEDs
LED Description
Link/Activity LED—100G, 40G, or 10G
• O—No link
• Solid green—Link operating at maximum speed, 100G for
QSFP28 port
• Flashing green—Port activity operating at maximum speed,
100G for QSFP28 ports
• Solid yellow—Port activity operating at a lower speed, 40G or
10G port
• Flashing yellow, 1 second on/o—Port beacon
Link/Activity LED—4x25G mode or 4x10G mode
• O—No link
• Solid green—Link operating at maximum speed, 4x25G port
• Flashing green—Link activity operating at maximum speed,
4x25G port
• Solid yellow—Link operating at a lowr speed, 4x10G port
• Flashing yellow, 1 second on/o—Port beacon
Link/Activity LED—2x50G mode
• O—No link
• Solid yellow—Link operating at a lower speed, 2x50G port
• Flashing yellow—Port activity at a lower speed, 2x50G port
• Flashing yellow, 1 second on/o—Port beacon
Prerequisites
The following is a list of components that are required and optional for successful switch installation:
NOTE
: For detailed installation instructions, see Site preparations and Z9264F-ON switch installation.
• Z9264F-ON switch or multiple switches, if stacking
• AC or DC country- and regional-specic cables to connect the AC or DC power source to each of the AC or DC power supplies
• Rail mounting brackets for rack installation, included
• M4 screws for rack installation
• #1 and #2 Phillips screwdrivers, not included
• Torx screwdriver, not included
• Ground cable screws for L-bracket, included
• Copper/ber cables
Other optional components are:
• M4 ground cable screw
• Extra power supply unit
• Extra fan module
NOTE
: The DC ground lug kit ships with the other accessories inside the shipping box.
Z9264F-ON switch 11
To Next Page
Loading...
