Management ports
Besides the 10/100/1000Base-T RJ-45 ports, the Z9264F-ON switch provides several ports for management and storage.
NOTE: The output examples in this section are for reference only. Your output may vary.
Topics:
• RS-232 console port access
• MicroUSB-B console port access
• USB storage mount
• Before you install an OS
• ONIE service discovery
RS-232 console port access
The RS-232 console port is on the I/O-side of the Z9264F-ON switch.
Figure 19. Z9264F-ON RS-232 console and management ports
• 1—RS-232 console port (top), RS-232 management port (bottom)
CAUTION
: Ensure that any equipment that is attached to the serial port can support the required 115200 baud rate.
NOTE: Before starting this procedure, ensure that your computer has a 9-pin serial port and that you have installed a terminal
emulation program on your computer.
NOTE: If the serial port on your computer cannot accept a female DB-9 connector, use a DB-9 male-to-male adaptor.
1 Install the provided RJ-45 connector-side of the provided cable into the switch console port.
2 Install the DB-9 female-side of the provided copper cable into the serial port on your computer.
Alternatively, install the DB-9 cable into other data terminal equipment (DTE) server hardware.
3 Keep the default terminal settings on the console as follows:
• 115200 baud rate
• No parity
• Eight data bits
8
34 Management ports
To Next Page
Loading...
