Dell EMC Z9264F-ON - After Switch Placement

For more information, see Unpack.
6 Conrm that the software version of the replacement switch is the same as the previously installed switch.
show os-version
If the software versions do not match, upgrade the replacement switch software using the procedure included with the rmware
download.
7 Copy the backed-up switch conguration to the new switch.
copy tftp://hostip/filepath running-config
8 Install the new switch in your rack or cabinet.
For detailed installation instructions, see Z9264F-ON switch installation.
If you are using the fan trays or PSUs from the removed switch, reinsert them in the replacement switch.
9 Connect all the cables.
10 Power on the switch.
For more information, see Switch power-up.
After switch placement
After you have securely installed and powered on the Z9264F-ON switch:
• If you are using Dell EMC software, see switch documentation at www.dell.com/support.
• If you need ONIE information, see ONIE documentation at www.onie.org.
• If you are using third-party software, see your third-party documentation.
Z9264F-ON switch installation
27