Figure 13. Z9264F-ON installation
1
Extra screws to restrict front-back movement of the switch. 2 Main screw
2RU front-rack installation
Congure the rails that are attached to the switch.
NOTE
: For more instructions, see the installation instruction labels on the rail.
1 Attach the inner switch rails to the Z9264F-ON switch.
Line up the rail with the mounting heads and attach the rail to the switch.
Slide the rail back until it locks into place.
2 Line up both switch rails to the previously mounted rack rails and slide the switch in until it is ush with front of rack.
To keep the switch from inadvertently sliding out of the rack and falling, about 3 inches before you fully insert your switch, the rail
locking feature engages.
24
Z9264F-ON switch installation
To Next Page
Loading...
