Diagnostic aids 3-29
3. Once the test is complete, the power indicator turns on solid, and either the message Disk Test/Clean
Test Passed or Disk Test/Clean Failed appears. If the message indicates failure, the disk is
unusable.
PRINTER SETUP
The triangles pointing up or down indicate whether there are additional menus. Touch the up or down arrows to
display these additional menus.
Note: If you make changes, touch Submit to make the change effective.
Defaults
US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.
The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.
Warning: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be
undone.
Printed Page Count
The page count can only be viewed and cannot be changed.
Touch Back to return to Diagnostics Menu.
Permanent Page Count
The permanent page count can only be viewed and cannot be changed.
Touch Back to return to Diagnostics Menu.
Serial Number
The serial number can only be viewed and cannot be changed.
Touch Back to return to Diagnostics Menu.
Engine Settings 1 through 4
Do not change these settings unless requested to do so by your next level of support.
Model Name
PRINTER SETUP
Defaults
Printed Page Count
Permanent Page Count
Serial Number
US
127
127
xxxxxxx
Submit
Back
Engine Setting 2 0
Engine Setting 1
0
To Next Page
Loading...
Need help?
General
