102 Removing and Installing Parts
www.dell.com | support.dell.com
Removing a Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1
Follow the procedures in "Before You Begin" on page 63.
2
Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
3
Remove the computer cover (see page 68).
4
Remove the drive panel (see page 90).
USB cable
*Media Card Reader
*
Not present on all computers.
To Next Page
Loading...
