Steps
1. Carefully insert the keyboard Flexible Printed Circuits (FPC) cable through the gap on the palm-rest.
2. Align and place the keyboard on the palm-rest assembly.
3. Gently press the keyboard and snap it into place.
4. Close the display completely and turn the system over.
5. Pull the keyboard FPC cable from the opening in the palm-rest.
6. Connect the keyboard FPC cable to the connector on the system board.
7. Route the battery cable through the routing channels between the system board and 3-cell battery.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
