NOTE: The display hinges should be at an angle of 0 degrees while the hinge caps should be at an angle of 90 degrees
(or of the position of a closed laptop).
NOTE: Ensure that the display hinges are rotated only to the unlock position, the hinge caps do not rotate until the
display hinges are in the unlock position.
Next steps
1. Install the display panel.
2. Install the display assembly.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Display cable
Removing the display cable
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the display assembly.
4. Remove the display panel.
About this task
The following image indicates the location of the display cable and provides a visual representation of the removal procedure.
50
Removing and installing components
To Next Page
Loading...
