Display back-cover and antenna assembly
Removing the display back-cover and antenna assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the display assembly.
4. Remove the display panel.
5. Remove the camera.
6. Remove the display hinges.
7. Remove the display cable.
About this task
NOTE: The display back cover and antenna assembly cannot be further disassembled once all the pre-removal parts
procedures are completed. If the wireless antennas or G-sensor module are malfunctioning and are required to be replaced,
replace the entire display back cover and antenna assembly.
The image below shows the display back-cover and antenna assembly after the pre-removal parts procedures have been
performed for any display back-cover and antenna assembly replacement.
Steps
After performing the pre-requisites you are left with the display back-cover and antenna assembly.
Installing the display back-cover and antenna assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
53
To Next Page
Loading...
