Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the installation
procedure.
Steps
1. Align the screw holes on the display hinges with the screw holes on the display back-cover.
2. Replace the four screws (M2.0x3.0) and the six screws (M2.5x2.5) to secure the display hinges to the display back-cover.
3. Rotate the display hinges close to an angle of 90 degrees.
4. Gently push the G-sensor cable and wireless antennas into the right hinge cap.
5. Gently push the display cable into the left hinge cap.
6. Replace the hinge rubbers to secure the left and right hinge caps.
7. Rotate the display hinges and the hinge caps downwards away from the display cover.
Removing and installing components
49
To Next Page
Loading...
