Dell Chromebook 3110 2-in-1 - Page 48

Steps
1. Rotate the display hinges and the hinge caps upwards toward the display cover.
NOTE:
The display hinges should be at an angle of 0 degrees while the hinge caps should be at an angle of 90 degrees
(or of the position of a closed laptop).
NOTE: Ensure that the display hinges are rotated to the unlock position only, the hinge caps do not rotate until the
display hinges are in the unlock position.
2. Remove the hinge rubbers that cover the left and right hinge caps.
3. Gently pull the display cable out of the left hinge cap.
4. Gently pull the G-sensor cable and wireless antennas out of the right hinge cap.
5. Rotate the display hinges open to an angle of 90 degrees.
6. Remove the four screws (M2x3) and the six screws (M2.5x2.5) that secure the display hinges to the display back-cover.
7. Lift and remove the display hinges from the display back-cover.
48
Removing and installing components