Steps
1. Connect the display cable to the connector on the back of the display panel.
2. For systems that support USI pen, connect the USI pen cable to the connector on the back of the display panel.
3. Adhere the rubber spacer on the display cable.
4. Adhere the conductive tape to secure the display cable to the back of the display panel.
5. Flip the display panel to align it with the display assembly.
6. Starting from the top corner, press on the display bezel and work around the entire bezel until it clicks onto the display
assembly.
Next steps
1. Install the display assembly.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Front-facing camera
Removing the front-facing camera
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the display assembly.
4. Remove the display panel.
Removing and installing components
45
To Next Page
Loading...
