Installing the world-facing camera
Prerequisites
CAUTION: This is a fragile component. Handle with care.
About this task
NOTE: The following procedure is applicable only for systems that are shipped with a world-facing camera.
The following image indicates the location of the front-facing camera and provides a visual representation of the installation
procedure.
Steps
1. Insert the world-facing camera module into the slot on the palm-rest assembly.
2. Replace the screw (M2.5x2.5) to secure the world-facing camera module to the palm-rest assembly.
Next steps
1. Install the world-facing camera cable.
2. Install the system board.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Display panel
Removing the display panel
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the display assembly.
About this task
The following images indicate the location of the display panel and provide a visual representation of the removal procedure.
40
Removing and installing components
To Next Page
Loading...
