3. Affix the three pieces of adhesive tape to secure the speaker cable in place.
4. Connect the speaker cable to the connector on the system board.
5. Affix the clear tape to secure the speaker cable in place.
Next steps
1. Install the 3-cell battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
World-facing camera cable
Removing the world-facing camera cable
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the system board.
About this task
NOTE: The following procedure is applicable only for systems shipped with a world-facing camera.
The following image indicates the location of the world-facing camera cable and provides a visual representation of the removal
procedure.
Removing and installing components
37
To Next Page
Loading...
