Steps
1. Align and place the world-facing camera cable on the palm-rest assembly.
2. Connect the world-facing camera cable to the connector on the world-facing camera module.
Next steps
1. Install the system board.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
World-facing camera
Removing the world-facing camera
Prerequisites
CAUTION: This is a fragile component. Handle with care.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the system board.
4. Remove the world-facing camera cable.
About this task
NOTE: The following procedure is applicable only for systems that are shipped with a world-facing camera.
The following images indicate the location of the world-facing camera and provide a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2.5x2.5) that secures the world-facing camera module to the palm-rest assembly.
2. Lift and remove the world-facing camera module from the palm-rest assembly.
Removing and installing components
39
To Next Page
Loading...
