Steps
1. Adhere and routethe display cable through the routing channels on the display back-cover.
2. Affix the tape, close to the left hinge cap, that secures the display cable in place.
3. Connect the camera cable to the camera module.
4. Gently push the display cable in the left hinge cap.
5. Replace the hinge rubber that secures the left hinge cap.
6. Rotate the left display hinge and the left hinge cap downwards away from the display cover. The display hinge should be at
an angle of 0 degrees while the hinge cap should be at an angle of 90 degrees (or of the position of a closed laptop).
NOTE:
Ensure that the display hinge is rotated only to the unlock position, the hinge cap does not rotate until the
display hinge is in the unlock position.
Next steps
1. Install the display panel.
2. Install the display assembly.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
52
Removing and installing components
To Next Page
Loading...
