1 release tab 2 card retention mechanism 3 card retention door
4 heat sink captive screws (2)
5. Use a long Phillips screwdriver to loosen the two captive screws, one on each side of the heat-sink assembly.
CAUTION: The heat-sink assembly may be very hot during normal operation. Be sure that it has had
sufficient time to cool before you touch it.
6. Rotate the heat-sink assembly towards the rear of the computer, and remove it from the computer.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (57 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
