1 system board 2 screws (10)
10. Remove the 10 screws from the system board.
11. Slide the system board assembly toward the front of the computer, and then lift the board away.
12. Place the system board assembly that you just removed next to the replacement system board to ensure that it is
identical.
Installing the System Board
1. Gently align the board into the chassis and slide it toward the back of the computer.
2. Replace the screws on the system board.
3. Replace any components and cables that you removed from the system board.
4. Install the memory modules that were removed from the old system board (see Installing Memory).
5. Reconnect all cables to their connectors at the back of the computer.
6. Replace the computer cover (see Replacing the Computer Cover).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into
the computer. Connect your computer and devices to electrical outlets, and turn them on.
If the new system board requires flashing the BIOS refer to Flashing the BIOS.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (66 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
