b. Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the
integrated connector on the back panel.
15. Install any drivers required for the card as described in the card documentation.
Removing a PCI Express Card
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
1 card retention door 2 release tabs (2) 3 lever on chassis wall (may not be present on all
computers)
4 filler bracket 5 alignment guide 6 alignment bar
3. If present on your computer, rotate the lever on the chassis wall upward.
4. Push the two release tabs on the card retention door from the inside to pivot the door open; the hinged door will remain
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (21 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
