Removing a Floppy Drive
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. Disconnect the power and floppy drive cables from the back of the floppy drive.
4. Unhook floppy drive cable from the clips on the processor shroud. Disconnect the other end of the floppy drive cable
from the system board. Remove the floppy drive cable from the computer.
1 power cable 2 floppy drive cable 3 floppy drive
4 sliding plate lever 5 sliding plate 6 processor shroud
5. Pull the sliding plate to the right and hold in place.
6. Slide the floppy drive out of the floppy drive bay.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (35 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
