CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer.
Removing the Processor Fan
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. If your computer includes a card retention mechanism to secure the x16 card, press the release tab downward gently
and then pivot the mechanism upward.
4. Unhook floppy drive cable from the clips on processor shroud and move out of the way.
1 release tab 2 card retention mechanism 3 card retention door
4 heat sink captive screws (2)
5. Use a long Phillips screwdriver to loosen the two captive screws, one on each side of the heat-sink assembly.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (61 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
