1 release button 2 power supply 3 screws (4)
4 AC power connector
Installing the Power Supply
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1. Slide the power supply into place.
2. Replace the four screws that secure the power supply to the back of the computer frame.
3. Reconnect the DC power cables.
4. Connect the AC power cable to the connector.
5. Run the cables underneath the clips, and press the clips to close them over the cables.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (48 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
