Dell Dimension 9200 - Error Messages

Documentation
10 PCI Express x1 card
connector
11 PCI Express x16 card
connector
12 PCI Express x4 card
connector
13 PCI card connectors 14 floppy drive connector
(FLOPPY)
15 PS/2 and Serial connector
16 card fan connector 17 thermal sensor connector 18 processor fan connector
19 processor and heat sink
connector
20 processor power connector
Memory
You can increase your computer memory by installing memory modules on the system board. For information on the type
of memory supported by your computer, see Memory.
Memory Overview
● Memory modules should be installed in pairs of matched memory size, speed, and technology for best performance.
Otherwise, the computer will continue to operate, but with a slight reduction in performance. See the label on the
module to determine the module's capacity.
1 memory module 2 memory module capacity label
NOTE: Always install memory modules in the order indicated on the system board.
The recommended memory configurations are:
❍ A pair of matched memory modules installed in connectors DIMM_1 and DIMM_2
or
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (6 of 68) [12/9/2007 11:22:24 PM]