1 power cable 2 hard drive cable
8. Check all connectors to be certain that they are properly cabled and firmly seated.
9. Replace the computer cover (Replacing the Computer Cover).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10. Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
Floppy Drive
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
NOTE: If you are adding a floppy drive, see Installing a Floppy Drive.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (34 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
