2. Follow the procedures in Before You Begin.
3. Remove the computer cover (see Removing the Computer Cover).
4. Press in on the tabs on each side of the hard drive bracket in the empty drive bay and slide the bracket up and out.
5. Snap the hard drive bracket onto the new hard drive.
NOTICE: Do not install any drive into the lower hard-drive bay until you have removed the hard drive bracket from
the inside of the hard drive bay.
6. Slide the new hard drive into empty bay until you feel a click.
1 hard drive 2 hard drive bracket
7. Connect the power and hard drive cables to the drive. Refer to General Installation Guidelines to identify the hard drive
cable connectors on the system board.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (33 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
