Dell Dimension 9200 - Page 40

Documentation
Integrated NIC
You can set the NIC to On (default), Off, or On w/PXE. When the On w/PXE setting is active
(available only for the future boot process), the computer prompts you to press <Ctrl><Alt><b>.
Pressing this key combination causes a menu to display that allows you to select a method for booting
from a network server. If a boot routine is not available from the network server, the computer
attempts to boot from the next device in the boot sequence list.
Integrated Audio
Enables or disables the onboard audio controller.
USB Controller
Set to On (default) so that USB devices will be detected and supported in the operating system.
USB for FlexBay
This field enables and disables the internal USB for FlexBay.
● Off — Internal USB for FlexBay is disabled.
● On — Internal USB for FlexBay is enabled.
● No Boot — Internal USB for FlexBay is enabled but not bootable.
The factory default setting is No Boot.
NOTE: This USB option appears only if a FlexBay device is installed.
Rear Quad USB
Enables or disables the 4-stack of USB ports on the back of the computer.
Real Dual USB
Enables or disables the 2-stack of USB ports on the back of the computer.
Front USB
Enables or disables the 2-stack of USB ports on the front of the computer.
PS/2 mouse port
If your computer has the optional PS/2 mouse port, then this option is listed.
Video
Primary Video
This setting specifies which video controller is primary when two video controllers are present on the
computer.
Performance
Multiple CPU Core
If your computer processor supports more than one core, this option appears in the Options List.
Virtualization
If your computer processor supports virtual technology, this option appears in the Options List.
SpeedStep
If your computer processor supports Intel® SpeedStep® technology, then this option is listed and it
allows you to enable or disable support for this feature.
HyperThreading
If your computer processor supports Hyper-Threading, this option appears in the Options List.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/syssetup.htm (4 of 11) [12/9/2007 11:19:53 PM]