3. Remove the computer cover (see Removing the Computer Cover).
4. Locate the battery socket (see System Board Components).
NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with
the object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out the
battery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on the
system board.
5. Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object, such
as a plastic screwdriver.
6. Insert the new battery into the socket with the side labeled "+" facing up, and then snap the battery into place.
1 battery 2 tab 3 battery socket
7. Replace the computer cover (see Replacing the Computer Cover).
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
8. Connect your computer and devices to electrical outlets, and then turn them on.
9. Enter system setup and restore the settings you recorded in step 1 (see Entering System Setup).
10. Properly dispose of the old battery.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (46 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
