3 Align the expansion card bracket with the hooks on the chassis.
4 Insert the card connector into the expansion card riser connector until the card is rmly seated.
NOTE: Ensure that the expansion card is properly seated along the chassis, so that expansion card latch can be closed.
5 If required, connect the cables to the expansion card.
Figure 56. Installing the expansion card in the expansion card riser
1
touch point (2) 2 expansion card riser connector
3 expansion card riser 4 expansion card
Figure 57. Installing the expansion card in the expansion card riser
1
PERC card 2 expansion card connector on the riser
100 Installing and removing system components
To Next Page
Loading...
